When using a microphone to record, the sound source generates two types of sound. One is called direct sound which enters the microphone directly from the source, and the other is called reflected sound which the sound it has been bouncing off the walls, ceiling and back into the microphone. Generally, the reflected sound can sound very different from home and the actual recording studio, despite the recording equipment and settings. In most cases, the reflected sound at home does not sound very good because the room is not built for recording. The sophisticated acoustic design creates better reflected sound which makes the recordings sound good in the standard recording studio. Let’s face it. It is very difficult to create a good home recording environment with right sound reflection. If the acoustic reflection does not resonance well, the recordings may not sound as clean and clear, and may be an interference to your mix especially it is difficult to shape your sound with reverb and delay. In these years, with the increased popularity of DAWs being used for editing with effects, it is more important than ever to record with a good sound quality in the beginning. When room acoustics does not sound good in the room, then the dry sound will be the essential solution for your home recording environment. The TM-AR1 Acoustic Control Filter does not only absorb the reflected sound but also isolates the reflections away from the microphone. By installing this tool, the microphone picks up only the direct sound with great frequency response, which enables your mixes and editing to be done with ease. To set up the TM-AR1, it is very simple. Just place it around the microphone, that’s it! It is particularly effective when used for recording vocal, wind instrument, acoustic guitar or any other instrument individually. You can get the dry and crisp sound in your DAW environment quicklywith ease.